Service manual

Page 4-10
seCTion 4 - serviCe & DisasseMbly
Drain Pump
Disconnect dishwasher from power and water supplies. Remove drain line.
Remove dishwasher from countertop.
Lay dishwasher on its back on a protective pad.
Remove wires from drain pump.
Removing coupling hose with drain pump aids in pump removal from sump.
The locks holding the pump to the sump are located on both ends of the sump mount.
Using a small blade screwdriver, push up on the locks, to release the pump. (See Figure 46)
Remove coupling hose from drain pump.
Reinstall in reverse order. Apply lubricant to the hose clamps for easier installation.
Wash Motor (See Figure 45)
Disconnect dishwasher from power and water supplies. Remove drain line.
Remove dishwasher from countertop.
Lay dishwasher on its back on a protective pad.
Slide hose clamps on the “Y” hose toward heater. Leave intake hose attached to motor.
To release motor mount (both front and rear), use blade of a small screwdriver to pry between
motor mount and motor mounting bracket. (See Figures 48 and 49)
To remove wire plug, place blade of a small screwdriver between disconnect and motor terminal
block to release lock. (See Figure 50 for location of lock)
Remove two wires connecting motor capacitor.
Remove hose from motor intake.
Reinstall in reverse order. Apply lubricant to hose clamps for easier installation.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
6.
7.
8.
9.
FIGURE 47
Check Valve
Lock Tab
MOUNT ON BACK OF THE
SUMP – FIGURE 46
Push up on lock to release
drain pump from mount