Planning Guide

All specications subject to change without notice.
Phone: [phone]www.dacor.com
PLANNING
GUIDE
DR30D, DR30DH, DR30DI, DR30DIH
Distinctive 30” Wide
Dual Fuel Range
Document # PG05-006
Revised 12/11/14 Page 4/6
Model DR30DI[H]
Range with
H J K
Option 1
24”
(61.0 cm)
NA
0” (0 cm) to
2 1/8” (5.4 cm)
Option 2
20 3/4”
(52.7 cm)
0” (0 cm) to
3 1/4” (8.3 cm)
0” (0 cm) to
5 3/8” (13.7 cm)
Countertop height for all self-rimming installations:
35 7/16” (90.0 cm) minimum, 37 7/16” (95.1 cm) maximum
Model DR30DI[H] Self-Rimming Installation Without
Downdraft Vent
■ Self-rimming installations create a “built-in” look where the trim of
the range overlaps the surrounding countertop. It is also possible, if
the cabinets are the right depth, to self rim the front of the range into
the cabinet face, immediately behind the control panel and door trim.
When the front of the range is self-rimmed, the 3 1/4” side panels are
removed.
■ For existing countertop cutouts that are 30 inches wide, contact your
dealer about custom trim kits.
OPTION 2:
MODEL DR30DI[H] SELF-RIMMED INSTALLATION CUTOUT
CABINET DEPTH: 21” TO 24 1/4”
(WITH 3 1/4 INCH SIDE PANELS INSTALLED)
OPTION 1:
MODEL DR30DI[H] SELF-RIMMED INSTALLATION CUTOUT
CABINET DEPTH: 24 1/4” OR GREATER
(WITHOUT 3 1/4 INCH SIDE PANELS INSTALLED)
Cabinet tolerances: -1/16”, (+1.6 mm) -0
Countertop
DR30DI[H] range
H
1/4” min. (6.4 mm)
flat countertop min.
Range trim resting
on countertop
See Top View for required distance
to vertical surfaces
Cabinet face
Back of
cutout
Back of
control
panel
3 1/4 inch
side panel
Cabinet face
Countertop
Back of control
panel and trim
behind door
rest against
cabinet face
DR30DI[H] range
1/4” min. (6.4 mm)
flat countertop min.
Range side
panels removed
Range trim resting
on countertop
See Top View for required distance
to vertical surfaces
H
Back of cutout
countertop opening
29 1/4” (74.3 cm)
30” (76.2 cm)
cabinet opening
below countertop
below countertop
To cabinet face
Notch countertop
overhang to width of
cabinets below
1/4” min. (6 mm)
countertop
overhang
10” min.
(25.4 cm)
both sides
To countertop
front
H
J
K
Combustible side
wall above range
Rear wall or other
vertical surface
1
1
Any vertical surfaces behind the range must be non-combustible
unless countertop overhang exceeds 2 3/4” (7.0 cm).
Rear wall or other
vertical surface
1
1
Any vertical surfaces behind the range must be non-combustible
unless countertop overhang exceeds 2 3/4” (7.0 cm)
2
Change to 29 1/4” (74.3 cm) to self rim front panel
countertop and
cabinet opening
Notch countertop to
29 1/4” (74.3 cm)
below countertop
Cabinet face
30” (76.2 cm)
1/4” min. (6 mm)
countertop
overhang
10” min.
(25.4 cm)
both sides
To countertop
front
H
K
Combustible side
wall above range
30” (76.2 cm)
2
cabinet opening
below countertop
TOP VIEWTOP VIEW
SIDE VIEWSIDE VIEW