Installation guide

Preparing for Installation
Ceiling or
Back wall cabinet
SX
J
‘]
bottom
S aS:
DN
° a) AS aes é
Duct Cut-Out for Rear Venting Duct Cut-Out for Top Venting
Installation Instructions
WARNING Blower Rotation Instructions
+ Do not install the range hood unless the electrical MODEL SEE PAGE
service provided meets the range hood specifica- EH3012, MH3012, EH3612, MH3612, 10
tions. EH4212
«Observe all governing codes and ordinances during FH4812, MH4812 11
installation. Contact your-local building department EH3018, MH3018, EH3618, MH3618,
for further information. FH4218 13
«A qualified technician must.complete the installa- EH4818, MH4818, EH5418 415
tion of this built-in appliance. More than one-person
is required to raise the hood into place. The owner
is responsible to make sure the hood is properly
installed.
1. Start by removing the filters from the bottom of the
hood. Put them in a safe location so that they will not
be damaged.
2. If the hood will be installed in a top exhaust configura-
tion, skip to page 16. If the hood will be installed so
that air will exhaust out of the back, the blowers must
be rotated into the correct position before hanging the
hood. The procedure for rotating the blower depends
on the hood model number. See the table at the right.
dacor 9