Installation guide

Installation Instructions
Final Electrical Installation
WARNING
«To avoid-electric shock or fire hazard, prior to-connecting the electrical wiring to the hood, make sure.that power-to
the hood. power supply line is turned off at-the fuse box or circuit breaker panel.
«Improper connection of the hood electrical wiring may.create an electric shock or fire hazard and:may result in dam-
age to the hood’s electrical system. See page.6 for:specifications.
«.-.Do not ground the hood to the neutral (white) power:supply.wire. Connect the hood ground wire to.a separate, prop-
erly grounded wire installed by a licensed electrician.
«Make sure all wire used is capable of handling the total connected load. See page 3.
1. Turn off power to the hood electrical circuit at the circuit 3. Connect the hood wiring to an electrical junction box
breaker or fuse box. on a dedicated circuit. See page 6 for specifications.
2. Feed the wiring through the wiring access holes in the Connect it according to the wiring diagram below or on
hood. Connect the wiring to the terminal block inside the following page.
the hood as shown.
To house circuit breaker
panel or fuse box \ Junction box
l | f
Wire nut,
3 places WHITE
\ WHITE _)
GREEN
C | GREEN BLACK
BLACK I
UL/CSA approved “
NEMA strain relief NN To range hood
Neutral (white) 3 Wire Connection to Junction Box
— Ground (green) _,
Hot (black)
To junction
box
Hood power
terminals
dacor 19