Installation Instructions

8
Assembling the Burners
WARNING
• Never operate the cooktop with burner parts removed.
• All burner air-mixture settings are done at the factory; do not try to
adjust these settings..
Remove the burner heads, rings, caps, and grates from their
packaging.
1. Assemble the burners as shown on this page:
a. Gather same-size components (i.e., large cap with large
ring, etc).
b. Center, and turn each piece until it seats properly. (The
burners will not function properly unless all components
are properly seated.)
NOTE
The burner base is permanently attached to the unit; it cannot be
adjusted/removed.
SimmerSear™ Burner Assembly
Inner burner cap
(bottom)
Outer burner cap
Burner ring
Burner base
Line up
indentations
with pins
Igniter
Burner cap
(bottom)
Burner ring
Burner head
Burner base
Igniter goes
through hole
CAUTION: Igniter
tip is sharp
Standard Burner Assembly
Installation Instructions