Installation Instructions

10
NOTE
SimmerSear
TM
burner: Turn the control knob to the simmer set-
ting, and ensure the low-level flame can be adjusted and the
burner indicator illuminates.
Troubleshooting
If the cooktop fails to function properly, review these steps:
• Verify that the cooktop receives power/gas.
• Verify that the cooktop is plugged in and power is turned on at
the power source.
• Verify that all the burners are correctly assembled/seated.
• If the burner sparks after ignition, have a licensed electrician
check the electrical outlet for correct grounding or reversed
polarity.
• Repeat Step 8 of the Verification procedure.
If the appliance still does not work, do not try to repair the appli-
ance, but contact Dacor Customer Assurance: 833-353-5483.
Have the model and serial numbers available. (See the inside
cover for this information.)
Dacor is not responsible for the cost of correcting problems
caused by faulty installation.
Verifying Proper Function
Perform this procedure for all cooktop burners.
WARNING
The cooktop must always be properly grounded when electrical
power is applied.
1. Turn off power to the electrical outlet at the circuit breaker or
fuse box.
2. Close the gas-supply valve.
3. Turn off all cooktop burner controls.
4. Plug in the power cord.
5. Turn on power to the electrical outlet at the circuit breaker or
fuse box.
6. Press-turn a burner-control knob slowly counterclockwise to
the flame icon (high flame).
a. Verify that the corresponding burner igniter sparks (rapid
tick-tick) and the burner indicator comes on.
b. Turn off the burner.
7. Turn the gas-supply valve ON.
8. Verify that the gas flame ignites on all burners:
a. Press-turn a control knob to the flame icon.
NOTE
• If ignition does not occur within 4 seconds, turn the knob OFF,
wait 5 minutes (for gas to dissipate), then repeat Step 8a.
• A proper flame burns steadily with a sharp, blue inner cone. The
Smart Flame™ feature reduces the flame under the grate fin-
gers to lengthen grate life.
b. After ignition, turn the knob clockwise to the OFF position.
Installation Instructions