Downdraft Planning Guide

All specications subject to change without notice.
Phone: [phone]www.dacor.com
PLANNING
GUIDE
ERV3015, ERV3615, ERV36-ER, ERV48, ERV48-ER,
PRV30, PRV36, PRV48
Renaissance Slim Chassis
Downdraft Vents
Document # PG08-001
Revised 02/28/14 Page 2/7
B
A
SIDE VIEW
FRONT VIEW
All tolerances: ±1/16” (±1.6 mm)
unless otherwise stated
WARNING
• Observe all governing codes and ordinances
during planning and installation. Contact your
local building department for further information.
• This appliance must be installed in accordance
with the accompanying installation instructions.
2 1/8" (5.4 cm)
3/8"
(1.0 cm)
2 1/8" (5.4 cm)
ERV top cap - side view
PRV top cap - side view
7/16"
(1.1 cm)
Model No. A B
Circuit
Requirement**
PRV30
30”
(76.2 cm)
27 3/8”
(69.5 cm)
Three prong electri-
cal outlet connected
to 120 Vac, 60 Hz,
15 Amp. grounded,
dedicated, circuit
PRV36
36”
(91.4 cm)
33 3/8”
84.8 cm)
PRV46
46”
(116.8 cm)
43 3/8”
(110.2 cm)
ERV48
48”
(121.9 cm)
43 3/8”
(110.2 cm)
** Includes power supply requirements for external blower
NOTES:
1. Maximum installed height must not exceed the maximum
specified countertop height of cooking appliance.
2. Install these downdraft vents only with approved Dacor
appliances. See the planning guide for the particular
appliance for proper applications and cutout information.
3. This appliance must be install in conjunction with a
single Dacor approved blower. See page 4/7 for approved
blowers.
4. Local building codes may require the use of makeup
air systems. Consult a qualified HVAC specialist when
designing the system for the requirements in your area
and to assure optimal performance.
DIMENSIONS - MODELS ERV48, PRV30, PRV36, PRV48