Downdraft Planning Guide

All specications subject to change without notice.
Phone: [phone]www.dacor.com
PLANNING
GUIDE
ERV3015, ERV3615, ERV36-ER, ERV48, ERV48-ER,
PRV30, PRV36, PRV48
Renaissance Slim Chassis
Downdraft Vents
Document # PG08-001
Revised 02/28/14 Page 3/7
30 ¼"
(76.8 cm)
to
37 ¼"
(94.6 cm)
10"
(25.4 cm)
30"
(76.2 cm)
18 5/8”
(47.3 cm)
5/16” (8 mm)
thick stiffener
across back
3 3/4"
(9.5 cm)
1"
(2.5 cm)
28" 3 prong
grounded
power cord
Vent shown
in raised
position
Product
data label
Motor
cover
Front of unit
6"
(15.2 cm)
2 9/16"
(6.5 cm)
2 1/2"
(6.4 cm)
1 15/16"
(4.9 cm)
B
A
Adjustable
anchor legs
2 13/16"
(7.1 cm)
1/4"
(6 mm)
Top cap with
vent down
All tolerances: +/- 1/16” (+/- 1.6 mm) unless otherwise stated
WARNING
• Observe all governing codes and ordinances
during planning and installation. Contact your
local building department for further information.
• This appliance must be installed in accordance
with the accompanying installation instructions.
Circuit Requirement (all models)*
Three prong electrical outlet con-
nected to 120 Vac, 60 Hz, 15 Amp.
grounded, dedicated, circuit
* Includes power supply requirements for
external blower.
NOTE: See the appliance planning guide page for cutout dimensions
Model Number A B
ERV36-ER 36” (91.4 cm) 33 3/8” (84.8 cm)
ERV48-ER 48” (121.9 cm) 43 3/8” (110.2 cm)
DIMENSIONS - MODELS ERV36-ER, ERV48-ER
NOTES:
1. Maximum installed height must not exceed the maximum
specified countertop height of cooking appliance.
2. Install these downdraft vents only with approved Dacor
appliances. See the planning guide for the particular
appliance for proper applications and cutout information.
3. This appliance must be install in conjunction with a
single Dacor approved blower. See page 4/7 for approved
blowers.
4. Local building codes may require the use of makeup
air systems. Consult a qualified HVAC specialist when
designing the system for the requirements in your area
and to assure optimal performance.