dacor anaes INSTALLATION WARMING For use with models: EW, EWO MW, MWO PW, PWO Iwo, [OWO Part No. 65034 Rev.
TABLE OF CONTENTS Important Safety INStructions oo... ee eee reer eeeeeeeeeeenenenaes 1 Design Specifications 0.0.0.0... eee eeeeeeeeneeeteneeenenenees 2-3 Product DIMENSIONS... cece cecccec cence en tttttttttesasanaeaeas 2-3 Installation Specifications... eee ee eeeeeeeteseneseneneeees 4-6 Installation Planning... ccecececesnsssssesesesaseseseeeeeeeeeeeess 4-5 Power Supply Requirements «0.0.0... c te seeeeeeaeeeeeeeeeeens 6 Installing the Support Platform in the Cabinet... 6 Installation Instructions...
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT INFORMATION ABOUT Safety Symbols and Labels SAFETY INSTRUCTIONS Immediate hazards that WILL result in severe personal injury or Important Safety Instructions and warnings appearing in these instructions are not meant to cover all possible conditions and death situations that can occur Common sense, caution and care must be exercised when WARNING installing, maintaining or operating an Hazards or unsafe practices that COULD appliance result in severe persona
DESIGN SPECIFICATIONS PrRopUCT DIMENSIONS NOTE: All tolerances are + 1/16,” - 0” unless otherwise stated.
DESIGN SPECIFICATIONS Overall Dimensions (IWO, IOWO) 40" (1016mm) 3 prong 120 Vac power cord 2 SS Mounting holes ° (rear holes > JS : oe oo Chassis view without drawer Drawer Face Dimensions (IWO Shown) Chassis << Ly model onl ) ————_| Dimensions (IOWO Shown) \ A Chassis NOTE: Only model lOW0O24 warming ovens are approved for outdoor use. They are designed for installation of a custom designed drawer front or for the Dacor Epicure® drawer front and handle.
INSTALLATION SPECIFICATIONS INSTALLATION PLANNING ® Aqualified technician must complete the installation of this built-in appliance. Proper installation is the responsibility of the customer. ® Carefully check the installation location. The oven should be placed for convenient access. Make certain that electrical power can be provided in the selected location. ® ® in Plan the installation so that all minimum clearances are met or exceeded.
INSTALLATION SPECIFICATIONS 00 top + ° a » d m- _ } ac a ° mm n ( 6mm) [ Pp —_—— @ mm) ( Warming Oven e ° : , + 4 6 mm) | pical counitop Na » electrical outlet PT y Single Installation to Side of Cooktop Tt utdoor ee 36" t e rill as Coo picure ° arming ven arming ven p ® top e\e [Ce] 3/4" Min c (9mm) + 120 Vac (914mm) TT electrical outlet 7 C qd f <5)"(16mmMin) 1 |< Stacked ——___»| Installation Below Cooktop or Grill clacar.
INSTALLATION SPECIFICATIONS Power SUPPLY REQUIREMENTS (A) WARNING Electric shock Hazard — This appliance is equipped with a 40’ (1016mm) power cord with a three prong grounded plug. Plug it only into a grounded three prong electrical outlet. The correct voltage, frequency and amperage must be supplied to the electrical outlet from a grounded, single phase circuit that is protected by a properly sized circuit breaker or time-delay fuse. Circuit Requirements: ® 120 Vac, 60 Hz, 15 Amp. dedicated circuit.
INSTALLATION INSTRUCTIONS VERIFYING THE PACKAGE CONTENTS + Use and care manual « Mounting screws « Wire rack with mounting hardware (IOWO INSTALLING THE CHASSIS WARNING model only) REMOVING THE DRAWER To avoid personal injury caused by the appliance falling forward when the drawer is opened, secure the chassis to the cabinet and support platform as instructed. WARNING 1. 2. Verify that the electrical outlet for the warming oven meets the Power Supply Requirements on 1.
INSTALLATION INSTRUCTIONS RE-INSTALLING THE DRAWER 1. Pull the drawer slides all the way out of the drawer opening. 2. Gently lower the drawer between the extended slides until the drawer is suspended by the slide rails. 3. Slide the back of the drawer mounting brackets under the drawer mounting clips on the slides. 4.
cdacor The Life of the Kitchen® Dacor e 1440 Bridge Gate Drive, Diamond Bar, CA 91765 e Tel: (800) 793-0093 « FAX: (626) 403-3130 e www.Dacor.