User`s manual

Changing the Battery
1) A mercury cell is located in the center of main board to keep setup da
t
of CMOS
2) If you see the case part, you could find protruding part(➁). Kee
pushing this protruding part and remove existing cell then install new
cell. If you are using metallic driver to push, try not to touch any othe
part with the metallic tool.
There is the danger of an explosion if the battery is incorrectl
replaced.
Replace the battery with the same or equivalent type
recommended by the manufacturer.
Discard used batteries according to the battery manufacturer’s
instructions.
[figure. 14]
Daewoo Telecom Lt
➁
push this
Side battery to this side.
AIO(DAE) 0.3.30 3:39 PM ∆‰¿Ã¡ˆ19