Service manual

DIRECTIONS FOR INSTALLATION AND USE

CLEANING THE LINT FILTER

• This washer has two Lint Filters in the top TUB in order to filter off lint and fuzz.

CLEANING THE WATER INLET FILTER

• Clean the filter when water leaks from the water inlet.

Return the filter as it was, and

insert the filter frame into the

slot.

Pull the Filter frame

upward.

Turn the lint filter

inside out, wash to

the lint off with water.

1 Pull the power plug out

before cleaning it.

2 Turn off the water sup-

ply to the washer and

separate the inlet hose.

3 Pull the inlet filter out. 4 Remove the dirt from

the inlet filter with a

brush.

CLEANING THE DRAIN FILTER

• In case “Pump-Model” drain hose, this filter’s equipped at the back side of washer.

• This drain filter is to screen the foreign stuffs such as threads, coins, pins, buttons, etc.

• If the drain filter is not cleaned at proper time (every 10 times of use), Drain problem could be caused.

1 Put down the remained water in

the hose. And put a container

under the filter to collect water.

2 Turn the cap counter clockwise. 3 Pull out the filter assembly off

the case.

4 Clean the drain filter removing

the foreign stuffs.

5 Put the filter into the case. And

turn the cap to adjust the promi-

nence of the filter to the hole of

the case.

6 Turn the cap clockwise tightly.

Lint Filter Filter Frame

FILTER

CAP

CASE

CONTAINER

FILTER

CAP

CASE

STOPPER