Installation manual

NEUTRAL INDICATOR
The neutral indicator is activated when the blue wire is grounded. Connect
this wire to the neutral switch or to the negative side of the neutral indicator light.
When the indicator is activated, a bar on either side of the odometer display will move
up and down as shown in the diagram.
NIGHT DIMMING
Your display system has a dimming feature that dims the display intensity. Normally the system is at full
brightness for daytime viewing. When the brown wire has 12 volts the display intensity will be reduced. A
toggle or on/off push button switch can be connected to this wire if this feature is desired. To have the system
at full brightness all of the time leave the brown wire disconnected.
LOW OIL PRESSURE AND LOW VOLTAGE INDICATORS
The low oil pressure warning is activated when the
gray wire is grounded. Connect this wire to the oil pressure
switch or the negative side of the oil warning light. The low
voltage warning is activated when the voltage at the red
power wire drops below 11 volts and there is a tachometer
signal. The warning message will be displayed in the
odometer area. Press the function switch will clear the
warning and return the mileage reading for 30 seconds. If
there is both a low voltage and low oil warning at the same
time, the low oil will be displayed.
TURN SIGNAL CANCEL OUTPUT
The display system also has a speed output signal for cycles equipped with an automatic turn signal
cancel module. The white wire from the main harness should be connected to the module where the wire from
the original analog speedometer was connected.
4