User Manual

Manual # 650602B
1b. Remove the four screws securing the gauge cluster to the dash. Unplug and remove the
gauge cluster.
1a.
First, park on level ground and put blocks in front of and behind the
tires and/or engage E-brake to secure the vehicle from rolling.
Remove the front plastic face by dropping the tilt steering all the way to the bottom and pulling the
gear shift lever into drive while making sure the vehicle will not roll. If no tilt, loosen the 15mm
nuts to drop the column. Pull the front face away from the dash to separate the clips, then
maneuver the panel to access the accessories connectors and disconnect so the face can be
completely removed.
2. At your own discretion, carefully cut directly above the stock gauge connector to allow more length on
the harness side for the required cut and splice wiring. Also, the harness connector will need to be
pushed out of the way to clear the VHX cluster; opening up the inner structure will allow space needed
for clearance, otherwise the connector will need to be removed.