Installation & Assembly

With additional help, carefully put the swing pod into the right position.
Put the cushion in the swing pod.
Step 6
Hang swing pod (H) on the frame with lock (F) and spring(G). Please refer to step 5
Step 5
Step 4
Attach the bend tube (E) to the sleeve tube(D) by using bolts(K) with washer(M) and nut (N)
Please refer to step 4.
Attach the sleeve tube (D) to the stand tube(C) by using bolts(K) with washer(M) and nut (N)
Please refer to step 3.
Step 3
Step 2
Attach the stand tube (C) to base by using bolts(L) with washer(M) and nut (N) .
Pls refer to step 2.
Step 1
Place all parts on a flat, sofa surface. Connect base (A) and base (B) by using bolts(L)
Please refer to step 1.
with washer(M) and nut(N).
Please make sure tighten all bolts on Step 1 first.
IMPORTANT!!PLEASE READ ENTIRE
INSTRUCTION SHEET BEFORE ASSEMBLY!!
PARTSLIST
Egg Chair
A
B
C
D
Do not attempt to assemble the product if any parts are missing or damaged .
Base A
Base B
Spring
Sleeve tube
Bend tube
Swing pod
M8*65mm
Bolt
Washer
E
F
G
H
I
J
1
1
1
1
1
1
Hex
L
Wrench
M
N
O
P
Q
2
R
S
U steel
Self-drill
holders
bolt
6
Screwed
spike
Anchor
bolt
6
Please refer to additional assembly instruction for placing egg chair + stand
on wood deck,lawn or cement surface.
CAUTION:
DO NOT USE WITHOUT SECURING EGG CHAIR AND STAND TO
GROUNDED STRUCTURE.
Stand tube
1
Lock
2
6
3
4
K
M8*25mm
Bolt
6
20
NUT
10
PE
NUT CAP
PE CAP
10
10
Warning:
-Maximum Capacity: 250 LBS
-Install on level ground, Install not less than 6 ft distance from any obstruction
-Check all nuts and bolts for tightness each time before and during use;
Oil all metallic moving parts during usage season