Installation Guide
Photo Features Xpress Mosaix Daphne White
Straight Stack Mosaic Tile
INSTALLATION INSTRUCTIONS | PEEL ‘N STICK MOSAICS | PAGE 2 OF 5
PRESS M O SAIX
™
BY
Installation of
PEEL ‘N STICK
MOSAICS
• Keep the protective backing on
while cutting the tile.
• A ceramic tile cutter is not
recommended if any cutting is
necessary. It is recommended to use
a diamond blade. It is important to
use the proper blades because blades
designed for ceramic tile will chip the
stone.
• If a wet saw is needed, ensure that the
mosaic is dry before adhering it to the
substrate.
• A utility knife can be used when
cutting along the joints
NOTE: Cut edges should be placed in
corners where they can be hidden.
• If drilling a hole in the tile is
necessary, it is recommended to use
a drill bit that is specially designed
for glass, metal and stone.
NOTE: The tile must be securely
clamped into place to prevent
movement of the tile during the
drilling process.
• When drilling the hole, keep the bit
and hole lubricated to prevent
chipping.
• Drill from both sides of the tile,
starting with the back and drilling half
of the depth of the tile.
• Turn the tile over and complete the
hole. This will prevent the glass,
metal and stone from chipping as
the drill bit exits the tile.
CONTINUED ON NEXT PAGE
STEP 3: CUTTING STEP 4: DRILLING