Installation Guide

Photo Features Xpress Mosaix Daphne White
Straight Stack Mosaic Tile
INSTALLATION INSTRUCTIONS | PEEL ‘N STICK MOSAICS | PAGE 3 OF 5
PRESS M O SAIX
™
BY
Installation of
PEEL ‘N STICK
MOSAICS
• Use a level to ensure the floor and/
or counter is level against the wall.
• Remove a small portion of the
protective backing and lightly stick
the corner of the tile into place. Once
the tile is in position, apply pressure
evenly down the sheet of mosaic
while simultaneously removing the
protective backer.
NOTE: For a stronger bond, remove the
protective backing. Apply 3/8” size
bead of polyurethane adhesive on all
four corners and center of the mosaic.
The adhesive needs to be applied 2“
away from the edge of the mosaic.
This step will allow a small range of
movement for placement correction
• Ensure that an 1/8” gap is left
between the mosaic and adjoining
surfaces (cabinets, countertops,
walls, floors and ceiling).
• A grout float can be used to tap
the tiles into place.
NOTE: When positioning and
placing the mosaic, make sure
the tile alignment is correct
before applying any pressure. After
pressure is applied, the mosaic will be
permanently bonded to the substrate.
Removal of the tile may cause damage
to the substrate.
• Use a silicone or flexible caulk to finish
the edges.
• A stone sealer is recommended to
protect the stone pieces.
NOTE: For more information on
proper sealants, please reference
Step 7.
CONTINUED ON NEXT PAGE
STEP 5: INSTALLATION