DKC054A1BSL2DB Owners Manual

INSTALLATION OF KEG COOLER

• This appliance is designed to be free standing only and should not be recessed or built-in.

• Place your keg cooler on a ﬂ oor that is strong enough to support the unit when it is fully loaded.

• Allow 8-12 cm (3-5 inches) of space between the back and sides of the keg cooler and any

adjacent wall to allow proper air circulation to cool the compressor.

• Locate the keg cooler away from direct sunlight and sources of heat (stove, heater, radiator,

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extreme cold ambient temperatures may also cause the keg cooler not to perform

properly.

• This unit is not designed for outside installation (i.e. garages, porches, patio, etc.).

• Avoid locating the keg cooler in excessive humidity.

• Plug the keg cooler into a dedicated, properly installed-grounded wall outlet. Do not under any

circumstance cut or remove the third ground prong from the power cord. Any questions concerning

power and or grounding should be directed toward a certiﬁ ed electrician or an authorized service

centre.

• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before

placing any contents in the keg cooler compartment.

BEER KEG INSTALLATION INSTRUCTIONS

Keg Installation Sketch

Pressure

Regulator

Faucet Assembly

Tower

Clear Hose with

Wing Nut

American Sankey

Tap (Coupler)

Keg

Coloured Pressure Hose

Tank

Installation Instructions

WARNING

GAS CAN BE DANGEROUS

cylinders contain high-pressure compressed gas which can be

hazardous if not handled properly. Make sure you read and understand all

safety procedures for CO

cylinders before installation.