Install Instructions

(Also see Appendix A)

The connection of the power supply and the LX (GFCI)

thermostat must be done by a qualified electrician in

accordance with the National Electrical Code (NEC) and

the Canadian Electrical Code (CEC). The electrician should

connect the floor sensor to the thermostat, take a final

resistance reading and record it on the warranty card.

It is important for the homeowner to mail in the

certificate immediately after installing the system

(cable and thermostat). Failure to do so could void the

manufacturer's warranty. The warranty is subject to

the guarantee conditions listed on the warranty

certificate.

Label 1:

Label 2:

Label 3:

Keep a copy of the warranty card for your

reference.

Product identification label

The eight digit product code provided on the LX cable

label must be recorded on the warranty certificate.

Electric panel label

This label is to be placed inside the electric panel. On this

label record the name of the room where the heating

cable has been installed.

The warning label

The warning label must be placed in the room where the

heating cable has been installed, preferably on the floor.

The label should be kept in the room at least for the

duration of the construction or renovation of the floor.

Step 8. CONNECT POWER SUPPLY AND

THERMOSTAT

Step 9. RECORD INFORMATION AND

AFFIX LABELS

The LX floor heating system is now ready to use. Increase

the floor temperature gradually and adjust it until it

reaches a comfortable level depending on the type of

room and your personal preferences.

Step 10. ENJOY THE COMFORT OF

DANFOSS LX

088L3390 - 06/2009