Install Instructions

 The installation shall be in accordance with the manufacturer's
instructions and national and local electrical codes. The installation shall
be in accordance with Part 424, American National Standard Institute /
National Fire Protection Association (ANSI/NFPA70), National Electrical
Code (NEC) and Canadian Electrical Code (CEC). Danfoss recommends
GFCI for heating cables in normally wet areas ( i.e. bathrooms, showers,
kitchens).

 It is important that this equipment is only installed by qualified
electricians who are familiar with the proper sizing, installation,
construction and operation of electric heating cable systems and the
hazards involved.




All local codes concerning buildings, electrical installations etc. must be
adhered to regardless of instructions provided in this manual. If these
regulations are in direct conflict with instructions stated herein, please
contact the Danfoss Electrical Heating Division.
Remember to check that the supply voltage matches the voltage required
for your particular Danfoss TX-FH product;
Extreme care must be used to ensure the TX-FH cables are not damaged
when using sharp tools or other implements. Avoid walking on the cables
or mats during installation;
Never cut the heating cable;
Do not install the Danfoss TX-FH cables in such a manner that two
heating cables touch, cross or overlap;
4
GENERAL NOTES
Read before beginning installation!
Copyright 2009 Danfoss Inc.
TEL: [phone]. FAX: [phone]
NA.EFHTH-FHM- 07/2009