Install Instructions

5
 M
 The Danfoss TX-FH electric heating system is most effective with tiled or stone or
concrete floors. If carpet, wood or other flooring materials are to be used, please
consult with Danfoss Electrical Heating Division.

 Ensure that all sharp stones and debris are removed from the area where the
heating cables are going to be installed.
 Make sure the cable is not subjected to excessive tension or strain, especially at
the heating cable to power lead slice.
 At low temperatures, the heating cable stiffens and may be difficult to work with.
To overcome this, connect the cable to the mains for a brief period of time.
Ensure the cable is fully rolled out when this is done.
 Do not install TX-FH cable in walls or ceilings
 Do not install the heating cables under cabinets, kitchen island etc.
 Never use

easure, verify and record the actual resistance throughout the installation
process:
1. Out of the box
2. After installation
3. After laying the mud bed
4. After connecting thermostat and/or contactors
Record these values in the warranty card. Failure to do so will void the warranty;
The TX-FH cable must be embedded in mortar or mortar mixture, concrete or
similar material.
the heating cables to cure the tile adhesive products.
Please consult the Danfoss Electrical Heating Division for any other questions,
concerns or advice.
GENERAL NOTES ( continued )
Read before beginning installation!
Copyright 2009 Danfoss Inc.
TEL: [phone]. FAX: [phone]
NA.EFHTH-FHM- 07/2009