User Guide
Table Of Contents
- 2. Menu Overview
- 3. Introduction
- 4. General Operation
- 5. Ground Fault: (GFCI) 1/2
- 5. Ground Fault: (GFCI) 2/2
- 6. Icons 1/2
- 6. Icons 2/2
- 7. Startup Wizard
- 8. Programed Heating Schedule
- 9. Operating Choices
- 10. Thermostat Setup Menu 
- 10.1 Heating Schedule 1/2 
- 10.1 Heating Schedule 2/2 
- 10.2 Energy Use 
- 10.3. User Settings 
- 10.4 Installer Settings 
- 10.4.1 Adaptive Function 
- 10.4.2 Open Window 
- 10.4.3 Sensor Application 1/2 
- 10.4.3 Sensor Application 2/2 
- 10.4.4 Sensor Type 1/2 
- 10.4.4 Sensor Type 2/2 
- 10.4.5 Floor Sensor Calibration 
- 10.4.6 Room Sensor Calibration 
- 10.4.7 Floor Protection 1/2 
- 10.4.7 Floor Protection 2/2 
- 10.4.8 Factory Reset 
- 11. Factory Settings
- 12. Troubleshooting 1/2
PAGE 39
© 2015 OJ Electronics A/S
10.3.3 Screen Saver
This option allows you to select the information to be shown on the screen when it
is idle.
• Large:temperature.Small:dateandtime.
• Large:time.Small:temperatureanddate.
• ScreenO.Thissettingminimizesenergyconsumption.
1. Tap the “Menu” button on the home screen.
2. Then tap the “User Settings” button to access the various user settings.
3. Tap the “Screen Saver” button.
4. Tap the information that you want to be shown in screen saver mode.
• Temperatureshowninlargeformat.Timeanddateshowninsmallformat.(See
example)
• Timeshowninlargeformat.Temperatureanddateshowninsmallformat.(See
example)
• ScreenO.
5. Confirm your choice with “√” or discard it with “X”.
The thermostat will automatically return to “User Settings”.
1
1
2
3
4
5
>
<
Contents