Specifications

No. Description Warning Alarm/
Trip
Alarm/Trip Lock Parameter Reference
67 Option Configuration has Changed X
68 Safe Stop (X)
X
1)
5-19
69 Pwr. Card Temp X X
70 Illegal FC configuration X
71 PTC 1 Safe Stop X
X
1)
72 Dangerous Failure
X
1)
73 Safe Stop Auto Restart
76 Power Unit Setup X
79 Illegal PS config X X
80 Drive Initialized to Default Value X
91 Analog input 54 wrong settings X
92 NoFlow X X 22-2*
93 Dry Pump X X 22-2*
94 End of Curve X X 22-5*
95 Broken Belt X X 22-6*
96 Start Delayed X 22-7*
97 Stop Delayed X 22-7*
98 Clock Fault X 0-7*
201 Fire M was Active
202 Fire M Limits Exceeded
203 Missing Motor
204 Locked Rotor
243 Brake IGBT X X
244 Heatsink temp X X X
245 Heatsink sensor X X
246 Pwr.card supply X X
247 Pwr.card temp X X
248 Illegal PS config X X
250 New spare parts X
251 New Type Code X X
Table 9.34 Alarm/Warning Code List
(X) Dependent on parameter
1) Can not be Auto reset via 14-20 Reset Mode
A trip is the action when an alarm has appeared. The trip
will coast the motor and can be reset by pressing [Reset]
or make a reset by a digital input (parameter group 5-1*
[1]). The original event that caused an alarm cannot
damage the or cause dangerous conditions. A trip lock is
an action when an alarm occurs, which may cause damage
to or connected parts. A Trip Lock situation can only be
reset by a power cycling.
Warning yellow
Alarm flashing red
Trip locked yellow and red
Table 9.35 LED Indication
General Specifications and ... Design Guide
172 Danfoss A/S © Rev. 06/2014 All rights reserved. MG11BC02
99