Operating instructions

1. Introduction

1.1.1. Copyright, Limitation of Liability and Revision Rights

This publication contains information proprietary to Danfoss A/S. By accepting and using this

manual the user agrees that the information contained herein will be used solely for operating

equipment from Danfoss A/S or equipment from other vendors provided that such equipment is

intended for communication with Danfoss equipment over a PROFIBUS serial communication link.

This publication is protected under the Copyright laws of Denmark and most other countries.

Danfoss A/S does not warrant that a software program produced according to the guidelines pro-

vided in this manual will function properly in every physical, hardware or software environment.

Although Danfoss A/S has tested and reviewed the documentation within this manual, Danfoss A/

S makes no warranty or representation, either express or implied, with respect to this documen-

tation, including its quality, performance, or fitness for a particular purpose.

In no event shall Danfoss A/S be liable for direct, indirect, special, incidental, or consequential

damages arising out of the use, or the inability to use information contained in this manual, even

if advised of the possibility of such damages. In particular, Danfoss A/S is not responsible for any

costs including but not limited to those incurred as a result of lost profits or revenue, loss or

damage of equipment, loss of computer programs, loss of data, the costs to substitute these, or

any claims by third parties.

Danfoss A/S reserves the right to revise this publication at any time and to make changes in its

contents without prior notice or any obligation to notify previous users of such revisions or

changes.

FC 100/ 200/ 300 DeviceNet 1. Introduction

MG.33.D3.02 - VLT

is a registered Danfoss trademark