Operating instructions

ManualsBrandsDanfoss ManualsMedia ConverterFC 100 Series

6. Parameters

8-01 Control Site

Option: Function:

[0]

Digital and ctrl. word Control by using both digital input and control word.

[1] Digital only Control by using digital inputs only.

[2] Control word only Control by using control word only.

The setting in this parameter overrides the settings in par. 8-50 to 8-56.

8-02 Control Word Source

Option: Function:

[0] None

[1] FC RS485

[2] FC USB

[3] Option A

[4] Option B

[5] Option C0

[6] Option C1

[30] External Can Select the source of the control word: one of two serial interfa-

ces or four installed options. During initial power-up, the fre-

quency converter automatically sets this parameter to

Option

[3] if it detects a valid fieldbus option installed in slot A. If the

option is removed, the frequency converter detects a change in

the configuration, sets par. 8-02 back to default setting

RS485

, and the frequency converter then trips. If an option is

installed after initial power-up, the setting of par. 8-02 will not

change but the frequency converter will trip and display: Alarm

Option Changed

This parameter cannot be adjusted while the motor is running.

8-03 Control Word Timeout Time

Range: Function:

1.0s

[0.1 - 18000.0 s] Enter the maximum time expected to pass between the recep-

tion of two consecutive telegrams. If this time is exceeded, it

indicates that the serial communication has stopped. The func-

tion selected in par. 8-04

Control Word Time-out Function

will

then be carried out. The time-out counter is triggered by a valid

control word.

8-04 Control Word Timeout Function

Option: Function:

[0]

Off

[1] Freeze Output

[2] Stop

FC 100/ 200/ 300 DeviceNet 6. Parameters

MG.33.D3.02 - VLT

is a registered Danfoss trademark