Operating instructions

ManualsBrandsDanfoss ManualsMedia ConverterFC 100 Series

[3] Jogging

[4] Max. Speed

[5] Stop and trip

[7] Select set-up 1

[8] Select set-up 2

[9] Select set-up 3

[10] Select set-up 4 Select the time-out function. The time-out function activates

when the control word fails to be updated within the time period

specified in par. 8-03

Control Word Time-out Time

Off

[0]: Resume control via serial bus (Fieldbus or

standard) using the most recent control word.

Freeze output

[1]: Freeze output frequency until com-

munication resumes.

Stop

[2]: Stop with auto restart when communication

resumes.

Jogging

[3]: Run the motor at JOG frequency until

communication resumes.

Max. freq.

[4]: Run the motor at maximum frequency

until communication resumes.

Stop and trip

[5]: Stop the motor, then reset the fre-

quency converter in order to restart: via the fieldbus,

via the reset button on the LCP or via a digital input.

Select set-up 1-4

[7] - [10]: This option changes the

set-up upon reestablishment of communication follow-

ing a control word time-out. If communication resumes

causing the time-out situation to disappear, par. 8-05

End-of-time-out Function

defines whether to resume

the set-up used before the time-out or to retain the

set-up endorsed by the time-out function. Note the

following configuration required in order to change the

set-up after a time-out: Set Par. 0-10

Active set-up to

Multi set-up

[9], and select the relevant link in par.

0-12

This Set-up Linked To

8-05 End-of-Timeout Function

Option: Function:

Select the action after receiving a valid control word following a

time-out. This parameter is active only when par. 8-04 is set to

[Set-up 1-4].

[0] Hold set-up Retains the set-up selected in par. 8-04 and displays a warning,

until par. 8-06 toggles. Then the frequency converter resumes

its original set-up.

[1]

Resume set-up Resumes the set-up active prior to the time-out.

8-06 Reset Control Word Timeout

Option: Function:

[0]

Do not reset

6. Parameters FC 100/ 200/ 300 DeviceNet

MG.33.D3.02 - VLT

is a registered Danfoss trademark