Operating instructions

Select Logic AND [2] to activate the Reverse command via the
fieldbus/serial communication port, AND additionally via one of
the digital inputs.
Select
Logic OR [3] to activate the Reverse command via the
fieldbus/serial communication port OR via one of the digital in-
puts.
NB!
This parameter is active only when par. 8-01
Con-
trol Site
is set to [0] Digital and control word .
8-55 Set-up Select
Option: Function:
Select control of the frequency converter set-up selection via
the terminals (digital input) and/or via the fieldbus.
[0] Digital input
[1] Bus Activates the set-up selection via the serial communication port
or fieldbus option.
[2] Logic AND Activates the set-up selection via the fieldbus/serial communi-
cation port, AND additionally via one of the digital inputs.
[3]
*
Logic OR Activate the set-up selection via the fieldbus/serial communica-
tion port OR via one of the digital inputs.
NB!
This parameter is active only when par. 8-01
Control Site is set to [0] Digital and
control word
.
8-56 Preset Reference Select
Option: Function:
Select control of the frequency converter Preset Reference se-
lection via the terminals (digital input) and/or via the fieldbus.
[0] Digital input
[1] Bus Activates Preset Reference selection via the serial communica-
tion port or fieldbus option.
[2] Logic AND Activates Preset Reference selection via the fieldbus/serial com-
munication port, AND additionally via one of the digital inputs.
[3]
*
Logic OR Activates the Preset Reference selection via the fieldbus/serial
communication port OR via one of the digital inputs.
NB!
This parameter is active only when par. 8-01
Control Site is set to [0] Digital and
control word
.
FC 100/ 200/ 300 DeviceNet 6. Parameters
MG.33.D3.02 - VLT
®
is a registered Danfoss trademark 57
6