Technical data

VLT 5000/5000 FLUX SyncPos Quick-Setup
MG.10.Q1.5B – VLT is a registered Danfoss trade mark34
O
O.ERR_3 ... xx ............................................................. 18
ON APOS .. GOSUB ................................................... 20
ON COMBIT .. GOSUB ................................................ 20
ON INT .. GOSUB ........................................................ 20
ON MAPOS .. GOSUB ................................................ 20
ON MCPOS .. GOSUB ................................................ 20
ON PARAM .. GOSUB ................................................. 20
ON PERIOD................................................................. 21
ON STATBIT .. GOSUB................................................ 20
ON TIME ..................................................................... 21
Option card layout ....................................................... 29
Option card terminals................................................... 24
OUT ............................................................................ 24
OUTDA........................................................................ 24
P
PC Software Interface .................................................. 11
PID control parameters................................................ 11
POSA............................................................................ 6
POSERR (15) .............................................................. 10
POSFACT_N (26)........................................................... 6
POSFACT_Z (23) ........................................................... 6
Proportional factor KPROP (11) ............................ 12, 18
R
RAMPMIN (31) .................................................. 6, 14, 15
RS485 connection ....................................................... 27
S
Safety regulations .......................................................... 2
Safety tips ..................................................................... 8
Sampling time .............................................................. 13
SET ............................................................................... 6
Setting of VLT parameters ............................................. 8
SETVLT ....................................................................... 19
Starting SyncPos .......................................................... 8
Supply voltages ........................................................... 28
SWNEGLIMACT (19) ................................................... 19
SWPOSLIMACT (20) ................................................... 19
Symbol bar.................................................................... 7
SyncPos Window .......................................................... 7
SYNCV ........................................................................ 12
T
Table of Messages ....................................................... 17
Technical data ........................................................ 24, 26
Terminal description ..................................................... 24
Terminals ..................................................................... 26
Test run program ......................................................... 10
TESTSTART ................................................................ 21
TIMER (14) .................................................................. 13
tolerated position error is exceeded ............................. 16
V
VEL .............................................................................. 18
VELMAX (1) ...................................................... 6, 13, 14
VLT control card terminals ............................................ 24
VLT parameters ....................................................... 8, 11
VLT software SyncPos messages ................................ 22
W
WAITNDX .............................................................. 17, 21
What to do if ...
maximum acceleration is not achieved ...................... 16
motor vibrates heavily .............................................. 10
stationary precision is required ................................. 15
there is a tendency towards instability....................... 15
tolerated position error is exceeded.......................... 16
Index