Installation & Assembly

the

1. Remove the showerhead from the shower arm by unscrewing the ball

joint counter-clockwise (Fig 1).

4. Remove any debris from the filter screen and from the flow controller.

Reinstall the flow controller by pressing into the opening of the showerhead.

Reinstall the filter screen by screwing clockwise into the ball joint threads.

Reattach the showerhead by screwing the ball joint clockwise into the shower

arm threads. Make sure to follow the original installation instructions shown

above.

2. The filter screen and flow controller are located at the opening of the

showerhead ball joint (Fig 2). Unscrew the filter screen from the ball

joint.

If necessary, use your needle-nose pliers (Fig 3).

3. Use needle-nose pliers to grasp the flow controller and pull the flow

controller out.

Take care not to use excessive force when grasping the

flow controller so as to avoid damage (Fig 4).