Installation Guide

Adjustable

Wrench

Llave ajustable

Pince à bec effilé

Clé à molette

Needle-nose Pliers

Alicates de extremos finos

Shown/Mostrado/Illustré

D460064/D460065

4 ½" Five Function S

howerhead

Pomme de douche de 4 ½ po (11,4 cm) à

cinq fonctions

Cabeza de ducha con cinco funciones de 4 ½ pulg

Remove the existing showerhead from the showerarm. Clean any debris from inside

the showerarm and showerarm threads. Run the water to flush residual debris from

inside the arm (Fig 1).

2. Wrap the threads of the showerarm with plumber's tape (included) (Fig 2).

Attach the new showerhead to the showerarm by turning clockwise. Tighten with a

wrench (Fig 3 & 4).

PAGE 1
4 ½" Five Function Showerhead Pomme de douche de 4 ½ po (11,4 cm) à cinq fonctions Cabeza de ducha con cinco funciones de 4 ½ pulg Adjustable Wrench Needle-nose Pliers Llave ajustable Alicates de extremos finos Clé à molette Pince à bec effilé 1. Remove the existing showerhead from the showerarm. Clean any debris from inside the showerarm and showerarm threads. Run the water to flush residual debris from inside the arm (Fig 1). 2.
PAGE 2
the 1. Remove the showerhead from the showerarm by unscrewing the ball joint counter-clockwise (Fig 1). 2. The filter screen and flow controller are located at the opening of the showerhead ball joint (Fig 2). Unscrew the filter screen from the ball joint. If necessary, use your needle-nose pliers (Fig 3). 3. Use needle-nose pliers to grasp the flow controller and pull the flow controller out. Take care not to use excessive force when grasping the flow controller so as to avoid damage (Fig 4). 4.
PAGE 3