Use and Care Guide

5
6
care & MaIntenance
Vitreous China Plumbing Fixtures
Clean the surface of your vitreous china toilet or lavatory with a mild
cleaner/soap and soft cloth.
Do not use abrasive cleansers, abrasive pads or steel wool to clean vitreous
china surfaces as it can result in scratching and dulling of the surface.
Do not use in-tank drop-in toilet bowl cleaners containing chlorine
or bleach. Do not expose plastic trim parts to strong oxidizing agents,
chlorine, or acid levels of lower than 5.0 ph. Most bowl/tile cleaners
contain such agents.
Use of in-tank drop-in cleaners containing chlorine or bleach can cause
tank component failure and damage. Our warranty excludes such
failures.
Use of in-tank drop-in cleaners containing chlorine or bleach voids
Fluidmaster® warranty and will result in damage to tank components
and may cause flooding and property damage.
Toilet Seats
Clean the surface of your toilet seat with a mild cleaner/soap and soft cloth.
Do not use abrasive cleansers, abrasive pads or steel wool to clean the
toilet seat surfaces as it can result in scratching and dulling of the surface.
danze VItreous chIna Warranty
Five (5) Year Limited Warranty – Vitreous China
Danze, Inc. (Danze) warrants to the original purchaser of this product that the vit-
reous china portion will be free from defects in material and workmanship under
reasonable use for a period of five (5) years from the date of original purchase, as
shown on the original consumer-purchaser’s receipt.
Limited Warranty On Parts
Danze warrants to the original consumer-purchaser of this product that the fol-
lowing parts will be free from defects in material and workmanship under reason-
able use for a period of years stated below from the date of original purchase:
Five (5) years:
Fluidmaster® fill valve
Tank lever
Three (3) years:
Flapper
•
•
•
•
•
•
•
•
•
Water will not shut off Debris inside the head may be obstructing the
seat. Remove cap, clean debris away and reas-
semble.
Refill tube is inserted too far into overflow
tube (below tank water level). Attach refill tube
adaptor to top of flush valve overflow. Flow
from the refill tube must be positioned directly
over the overflow tube.
Water dripping from cap dur-
ing refill
This is normal for pilot type valves. This feature
allows the pilot valve orifice to self clean dur-
ing refill. The water may continue to drip for
10 or 15 seconds at the end of the refill cycle.
It should stop when float rises to the full “off”
position.
Water dripping from air ports
during refill
This may indicate a very low water pressure
condition. The dripping should stop when float
rises to the “off” position.
Too little water in bowl Insure refill hose is directed into overflow tube
and the flow is not obstructed or restricted.
Poor Flush Adjust water level in tank to line marked on the
inside back wall.
Fully open water supply shut-off valve.
Clear obstructions from the bowl rim holes, jet,
or trapway.
No Flush Flapper chain is not connected. The chain
should be attached to the tank lever and the
flapper.
Too much slack in the flapper chain. Insure
chain has some slack when at rest but can fully
lift the flapper when the tank lever is actuat-
ed.
Noise Debris inside the head may be creating noise/
vibration when the fill valve is flowing. Remove
cap, clean debris away and reassemble.
The flow rate of the incoming water sup-
ply may be excessively high. Partially close
the water supply stop to reduce the noise.
Open / close the water supply stop to achieve
approximately 60 second tank refill time.