MSDS

SDS Number: 00000694004 Revision Date: 5/20/2015
The text for GHS Hazard Statements shown above (if any) is given in the "Other information" Section.
4. First-aid Measures
FIRST AID - INHALATION: Material is not likely to present an inhalation hazard at ambient conditions. If you experience difficulty in
breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately.
FIRST AID - SKIN CONTACT: Wash skin with soap and water for 15 minutes. Get medical aid if symptoms persist.
FIRST AID - EYE CONTACT: In case of contact, immediately flush eyes with large quantities of water for at least 15 minutes until
irritation subsides. Get medical attention immediately.
FIRST AID - INGESTION: If swallowed, DO NOT INDUCE VOMITING. Get medical attention immediately.
5. Fire-fighting Measures
UNUSUAL FIRE AND EXPLOSION HAZARDS: None known.
SPECIAL FIREFIGHTING PROCEDURES: Wear self-contained breathing apparatus pressure-demand (NIOSH approved or
equivalent) and full protective gear. Use water spray to cool exposed surfaces.
EXTINGUISHING MEDIA: Carbon Dioxide, Dry Chemical, Foam, Water Fog
6. Accidental Release Measures
ENVIRONMENTAL MEASURES: No Information
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled material and remove with inert absorbent.
Dispose of contaminated absorbent, container and unused contents in accordance with local, state and federal regulations. Scrape up
dried material and place into containers. Use personal protective equipment as necessary. In case of spillage, absorb with inert
material and dispose of in accordance with applicable regulations.
7. Handling and Storage
HANDLING: KEEP OUT OF REACH OF CHILDREN!DO NOT TAKE INTERNALLY. Avoid breathing vapor and contact with eyes,
skin and clothing. Use only with adequate ventilation. Ensure fresh air entry during application and drying. Wash thoroughly after
handling. Remove contact lenses before using. Do not handle contact lenses until all sealant has been cleaned from fingertips, nails
and cuticles. Residual sealant may transfer to contact lenses and cause severe eye irritation.
STORAGE: Avoid excessive heat and freezing. Do not store at temperatures above 120 degrees F. Store away from caustics and
oxidizers.
8. Exposure Controls/Personal Protection
Ingredients with Occupational Exposure Limits
Chemical Name ACGIH TLV-TWA ACGIH-TLV STEL OSHA PEL-TWA
OSHA PEL-CEILING
No hazardous items exist
Further Advice: MEL = Maximum Exposure Limit OES = Occupational Exposure Standard SUP = Supplier's Recommendation Sk
= Skin Sensitizer N.E. = Not Established
Personal Protection
RESPIRATORY PROTECTION: No personal respiratory protective equipment normally required.
Page 2 / 5