Technical Specifications

9/28/2020
Product Application
Quart & Gallon:
1. Remove lid.
2. Use a paint brush or trowel to apply sealant onto surface, using even strokes.
3. Extend coverage 3” to 4” beyond problem areas to ensure adequate seal. Apply generously & avoid
overspreading. Apply 1/8” to ¼” thick, but not over ¼” thick due to flammability concerns.
4. When applying to wet surfaces, tool & push onto the surface to displace water & ensure adequate
bond.
5. Allow each coat to dry completely before applying additional coats (up to 24 hours).
6. Clean up excess wet sealant from surface & tools with mineral spirits, avoiding solvent contact with
skin. Wash hands or skin with soap & water.
7. Allow sealant to dry 24 hours (longer in cool, humid conditions) before painting. Latex paint only is
recommended.
8. Reseal for storage & reuse. Store in a dry place, below 80°F.
Cartridge:
1. Cut nozzle at 45° angle to desired bead size. Puncture inner foil seal. Load into caulk gun.
2. Gun sealant into the joint or gap.
3. When applying to wet surfaces, tool & push onto the surface to displace water & ensure adequate
bond.
4. Sealant is toolable for up to 10 minutes. Wear gloves if tooling by hand.
5. Clean up excess wet sealant from surface & tools with mineral spirits, avoiding solvent contact with
skin. Wash hands or skin with soap & water.
6. Allow sealant to dry 24 hours (longer in cool, humid conditions) before painting. Latex paint only is
recommended.
7. Reseal for storage & reuse. Store in a dry place, below 80°F.
Typical Uncured Physical Properties
Appearance/Consistency
Clear, brushable/gunnable paste
Base Polymer
Synthetic rubber
Filler
Not applicable
Volatile
Xylene and Exempt Solvent
Weight % Solids
Qt & Gal: 43% Cartridge: 66%
Density (lbs per gallon)
Qt & Gal: 8.7 Cartridge: 7.7
Odor
Strong solvent
Clean Up
Mineral spirits
Flash Point
81°F (27.2°C)
Freeze Thaw Stability (ASTM C1183)
Will not freeze
Shelf Life
12 months
TYPICAL PHYSICAL & CHEMICAL PROPERTIES