Instructions / Assembly

• Use Acetone nail polish remover to remove cured Rapid-

Fuse from your skin. Wash your hands ﬁrst to remove any

un-cured adhesive with soap and water, then wipe with

an acetone-soaked cotton pad. Do not try to pull or peel

RapidFuse off of your skin.

• RapidFuse can be cleaned up with soap and water when it

is wet. Once dry, you will need to use acetone nail polish re-

mover to clean up excess. Put the acetone on a paper towel

and wipe to remove. Do not pour acetone on bonded areas.

• Cured RapidFuse can be sanded or scraped to remove dried

excess.

How to Clean-Up RapidFuse

Visit rapidfusewood.dap.com for more product information and application tips + tricks.

™

Application Tips:

RapidFuse has a long open time—if you don’t

touch and spread it. It will remain open for up to

40 minutes if you put adhesive straight down. If

you use the ﬁne tip applicator to spread it around,

then you have about 3 minutes for open time (same as

reposition time) to make a bond.

RapidFuse is not gap ﬁlling—the two substrates

you are bonding need to touch with pressure.

Any glue that squeezes out during clamping should

be wiped away with a dry paper towel. If you leave

excess, then it may not cure. Once you remove the

excess the adhesive will then cure properly.