Installation & Assembly

NOTE : Should any difficulty be experienced, please consult a qualified electrician
before installing.
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT
OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
WARNING
:
Installation steps:
1. Turn off the electricity at the Fuse or
Circuit Breaker before installation.
2. Attach the Cross Bar to the Outlet Box by using 2PCS of
Mounting Screws upwards.
3. Attached the Loop to the Nipple-2.
4. There are one set of extra Metal Ball Nuts inside the package,
You can change the Crystal Nuts to be the spare metal pieces
to your options,Please adjust the length of Small Nipple from
the Side Channels if the Metal Ball Nuts do not fit well.
CAUTION: PLEASE DO NOT CHANGE THE BALL NUTS
WHEN THE FIXTURE HANING TO THE CEILING
IN CASE THE GLASS FALLING OFF FROM
THE FRAME.
5. Choose a certain length of the Chain you need,
and weave the Fixture Wire and the Ground
Wire through the Chain links,then
attached one of the Adjustable Loops to the Top
Loop and the other one to the Loop.
6.Thread the fixture wire and the Ground Wire
through the Top Nut, Top Loop, Adjustable Loop,
Canopy, Nipple-1 and the Cross Bar in order.
7.Make wire connections with Wire Connectors:.
----Connect the Wire (W/ marking) from
the light to the Black Wire from the Outlet Box.
----Connect the Wire (W/O marking) from the light to the White Wire from the Outlet Box.
----Attached the Ground Wire and House Ground Wire to the Cross Bar with a Green Screw.
Carefully tuck wires back into the Outlet Box.
8.Attached the Canopy to the Cross Bar by inserting the Nipple-1 , then secure with the Top Loop and Top Nut.
9.Put the Glass to the Sockets and secure with the Socket Ring then install Bulbs.
(Bulbs are not included, please do not exceed the maximum capacity which is recommended on the
Candle Cover.)
10. Turn on the power at Fuse or Circuit Box and enjoy your new fixture.
SIDE CHANNEL
ASSEMBLY AND INSTALLATION
INSTRUCTIONS