Installation manual

Tools Needed

You may need some or all of the following tools and other items to complete the

upgrade:

• A medium Phillips-Head screwdriver

• A medium slot-tip screwdriver

•

Cabled ISS Only: Wire cutters

• Other tools as required to remove and re-mount the ISS

•

Wireless ISS Only: CR-123A 3-volt lithium battery (optional)

Note: If you are upgrading an ISS that has been in service for a year or more, you should consider

changing the ISS battery during the upgrade.

Installation Overview

Installing the Daytime Fan Kit is not very complicated and should take only 30 to 60

minutes to complete.

These are the steps to install the Daytime Fan components:

1. Put the console into Setup Mode.

2. Take the ISS down from its installed position.

3. Disassemble the standard radiation shield.

4. Remove the solar panel if you have a Wireless ISS.

5. Assemble the lower section of the fan-aspirated shield.

6. Install the fan unit.

7. Assemble the upper section of the fan-aspirated shield.

8. Re-Install the ISS.

9. Take the console out of Setup Mode.

#8 Split-Lock Washers (6)

#8 Flat Washers (6)

#4 x 3/8" Screw

#4 Flat Washer

Cable Clamp

#8-32 x 3-1/4"

Screws (3)

Power Cable

Assembly

#8-32 x 1/2" Screws (3)

Threaded Spacers (3)

4" Cable Tie

12" Cable Ties (2)

Cable Tie Mount

Figure 2. Daytime Fan Kit Hardware