Installation manual

3
Installing the Daytime Fan Kit
Put Console in Setup Mode
1. At your Vantage Pro console, press and hold the DONE key and then press the -
key to put the console in Setup Mode. This prevents the reception of erroneous data
from the rain collector while you are removing the ISS.
Note: If the console acquires erroneous data during the upgrade, refer to “Take the Console Out of Setup
Mode” on page 14 for instructions on clearing data. Additional information on clearing and setting
console data can be found in the “Vantage Pro Console Manual.”
Take Down the ISS
CAUTION: Please work on your Vantage Pro ISS in a safe place. We strongly recommend that you take
down the ISS before beginning the upgrade.
If you are installing the Daytime Fan Kit on an ISS that has already been placed into
service, you will need to take down the ISS and move it to a convenient and safe place to
perform the installation.
1. At the ISS, open the Sensor Interface Module (SIM) housing cover and disconnect
the WIND (anemometer) cable.
Note: The SIM housing is located on the bottom of the radiation shield.
2. Cabled ISS Only:
Disconnect the console cable from the SIM.
3. You can now remove the ISS from its mounted position. Move it to a safe place to
install the kit components.
Cable Routing Channels
(press cables fully into channel)
DIP Switches
(Wireless ISS Only
)
Console Cable
(Cabled ISS Only)
Solar Panel Power
(Wireless ISS Only)
AC Power
(optional)
3-Volt Lithium Battery
(Wireless ISS Only)
UV
Optional
SUN
RAIN
WIND
TEMP HUM
SIM Housing
Figure 3. SIM Connections