User Manual

26
iLM8 – Live User Manual
Infinite Avg. for Surround and Stereo, Measured value of C > 4.0 Bed, Short loudness Avg. of
an individual Surround Channel (L, R, C, Ls, Rs), True Peak for Surround and Stereo, Max – TP
for Surround and Stereo, LRA for Surround and Stereo.
4. Indicates the current measurement that is displayed in Field #1.
5. Indicates the current measurement that is displayed in Field #2
6. Indicates the current measurement that is displayed in Field #3
7. Play / Stop / Reset Infinite Average icon. Selecting this icon while on the Home Screen and
pressing ENTER will ‘stop’ the Infinite Average. Pressing ENTER once again will ‘reset’ the
Infinite Average. Pressing ENTER once more will ‘play’ and resume calculations for
determining the Infinite Average for the selected display input.
8. Pause / Resume Infinite Average icon. Selecting this icon while on the Home Screen and
pressing ENTER will ‘pause’ the Infinite Average. Pressing ENTER once more will ‘resume’
calculations for determining the Infinite Average for the selected display input.
9. Headphone adjustment icon. Pressing ENTER while in Home Screen selection mode will
display the HEADPHONE VOLUME menu.
Target
Defines the loudness level that the Mix Monitor uses to benchmark against. The default is +/- 2 LU.
Inbound audio that is +2 LU over the set target level will illuminate ‘OVER TARGET’ on the Mix Monitor.
Inbound audio that is -2 LU under the set target level will illuminate ‘UNDER TARGET’ on the Mix
Monitor. Any inbound audio that is within +/- 2 LU of the target level is illuminated ‘ON TARGET’ on the
Mix Monitor. The Mix Monitor is adjustable to +/- 4 LU.
Target Range is -31.0 LKFS to 0 LKFS
Auto Infinite Average
Turns the infinite average on an off when an inbound audio signal is below the selected threshold. The
default threshold is -60 LKFS. Any inbound audio below (-60 LKFS) for longer than 400 Msec will stop
the Infinite Average. It will hold that calculation in memory and display it on the Home Screen until an
inbound audio signal that is greater than the threshold (-60 LKFS) is detected for longer than 400 Msec.
The ‘STOP’ icon is displayed when the Infinite Average is stopped. The infinite average will then reset
itself and begin calculating again.
If Auto Infinite Average is enabled the Home Screen will display ‘Auto Inf Avg’ in place of ‘Infinite Avg’.
The Threshold range can be set from 0 to -99 LKFS. If Auto Infinite Average is not enabled, Threshold
is not selectable.
A Time Limit can be set to trigger the Auto Infinite Average ‘ON’ and ‘OFF’. 100 – 3000 Msec.
Defaulted to 100 Msec