User Manual

iLM8 – Live User Manual

Select the input channel pair to be modified and press ENTER. Scroll the rotary encoder to the desired

HD/SDI channel pair and press ENTER to confirm. Repeat for the other channel pairs, as needed.

GPO Set allows the operator to use the GPO for either Alarm conditions or as a Mix Monitor.

Alarm sets GPO 1 & 2 to alert the user of AES Lock Loss and Hardware Failures

Mix Monitor sets GPO 1 & 2 to alert the user when the measured loudness is ‘OVER’ and ‘UNDER’

the selected target level.

Network Menu

Figure 11. Network Menu Screen Display

The DaySequerra Eclipse iLM8 - Live has several configurable network settings. All of iLM8 - Live’s

network settings are password protected. The password to change the network settings is ‘ds123’.

Please take note when entering the password that the iLM8 - Live password is case sensitive. The

DaySequerra iLM8 - Live is configured to take a DHCP address by default.

Device Name: Allows you to change iLM8 - Live’s name as reported to DNS. Press ENTER while the

cursor is over this field to go into data entry mode. Turn the knob to scroll through the available choices

of letters (A-Z, 0-9 and _ (underscore)) and press ENTER to move on to the next field. Turning the knob

again will start to scroll through the choices for the next letter, or pressing ENTER accepts the name.

DHCP: Configures iLM8 - Live to look for a DHCP server for IP configuration. (Enabled or Disabled)

IP Address: disabling DHCP allows you to enter an IP address manually. Press ENTER while the

cursor is over this field to go into data entry mode. Scroll through the available numbers (0-255) and

press ENTER to move to the next octet.

MAC Address: Displays iLM8 - Live’s MAC address if needed for firewalls or DHCP IP address

assignments.