User Manual

23"
!!!!!!!M4FM-HD User Manual
2. Carrier Measurements (Bargraph) – displaying Positive, Negative and Total Positive +
Negative in percent. Integer values of these measurements are available in the M4FM-HD’s
meters submenu.
3. Subcarrier Measurements (Integer) – displaying Pilot, 57 KHz, 67 KHz, and 92 KHz levels in
percent
Alarms Tab
1.
Figure 19.
1. Alarm configurations – sets the individual conditions for each of the 6 alarms.
*Slide the Enable switch to the right to enable an alarm.
The M4FM-HD box user interface will display the exact state of the alarm under ‘Status’ Enable = Alarm
ON, Disable = Alarm OFF.
Enabling any one alarm will disable tuning. Disable ‘Alarms Lock Tuning’ from the ‘Other Settings’
section of the webservers SYSTEM tab to turn this feature off. By default the Alarms Lock Tuning is
enabled.
2. Alarm Status – READ-ONLY window that displays the real-time status for each of the set alarms.
2.
3.