Established in 1977 Like Us Share Us KG04501BK 2004 to 2011 HUMMER H3 and H3T Watch Us Follow Us 12 www.Daystarweb.com Tech Support Contact Info Tech@DaystarWeb.com Phone: 623.907.0081 Fax: 623.907.0088 841 South 71st Avenue 1 Phoenix, AZ 85043 Instruction Sheet: P20166-02 2013 Daystar Products International Inc.
Introduction is your number one source for Made In The USA quality, Comfort Ride™ leveling kits. Now backed with our exclusive Go Everywhere © Lifetime Limited Warranty (see terms at Daystarweb.com). To assure your safety and proper installation of this product, take a moment to read all instructions and Product Safety Information before trying to install your Daystar® product.
Tools Needed 21. Remove all jacks and jack stands from under vehicle. 22. Center the steering wheel. 23. With the vehicle on the ground cycle the steering wheel side to side and inspect suspension components, brake lines and tires to ensure there are not any clearance issues. Jounce the suspension to assure front suspension operates freely, brake lines retain proper slack at full extension and that they remain clear of springs or other obstructions. 24.
Top of Fan Shroud !Warning: Always work with appropriate personal safety gear including safety glasses, gloves and hearing protection if using air powered tools. Begin by inspecting the components & hardware for damage. Then compare components & hardware to the bill of materials for completeness. If anything is missing/damaged, do not proceed with the installation. Please, call Daystar Products (800-5957659) and we will send you the missing of damaged components free of charge.
Installation Instructions Hummer H3T Body Lift Loosen then Install spacer Bed Support Pads ( H3T ONLY) There are four Bed Support Tabs supplied in the kit, you will need to install these when you are installing your body lift spacers for the bed. The location of where these will go is just behind the front bed spacers, and just in front of the read bed spacers.
Bumper Cap The Rear Bumper Cap will require removal and trimming of the two triangle tabs on top side of the bumper cap. To remove the cap simply pop the two plug caps at the top and remove the screw using a Phillips head screw driver. You will then want to go underneath of the bump cap and remove the torx head screws, once loose locate the push style clips on the back side of the bumper cap, depress and slightly pry up on the bumper cap.
