Installation Guide

DISCARD PACKAGING

OPTIONALLY ATTACH BOTTLE HOLDER

(PURCHASED SEPERATELY) TO BEVERAGE CHILLER

Recycle responsibly

Model may vary from illustrations shown

Inspect the product(s) to verify that there is no shipping damage. If any damage is detected, call the

shipper and initiate a damage claim. DCS by Fisher & Paykel is not responsible for shipping damage.

NOTE: Do not discard any packing material until the unit has been inspected.

Examine the product to be sure there are no dents or scratches or discoloring.

PREPARE THE CAVITY

Ensure the base of the cavity is level, square and able to

support the weight of the product when full.

Any cabinet and/or ground preparation must be completed

prior to installation.

All support structures must be constructed of materials

resistant to moisture damage.

Do no use harsh products (acid, solvent, sealers) around

this product.

For installation with the Bottle holder (purchased

separately), the cutout must extend to the front of the

cabintry, allowing space for the bottle holder (as shown).

CUTOUT WITHOUT

BOTTLE HOLDER

CUTOUT WITH

BOTTLE HOLDER

INSTALLING BEVERAGE CHILLER / BOTTLE HOLDER (PURCHASED SEPERATELY)

Fit the bottle holder onto the front of the Beverage chiller.

Attach the bottle holder to the Beverage chiller with the screws provided.

Unwrap the drip tray and fit in the bottom of the bottle holder.