Installation Guide

9
Allow min. 1 ⁄” (28mm)
clearance from the cutout to a
corner
Allow min. 4” (102 mm) clearance
from the cutout to a corner
Refer to Pantry installation for corner installations with a
pantry unit or beverage unit with bottle holder.
measured from
back of frame
measured from
back of frame
9a
PREPARE THE CAVITY
Ensure the cavity is level, square and able to support the weight of the product
when full.
Any cabinet and/or ground preparation must be completed prior to installation.
All support structures must be constructed of materials resistant to moisture
damage.
Do no use harsh products (acid, solvent, sealers) around this product.
1 Depending on your construction, place either a shelf or at least two
(min 2” (51 mm) wide) moisture resistant supports in the cutout.
Ensure all support boards are flat and level.
16 ½”
(420 mm)
20 ½”
(520 mm)
1 ¼”
(31 mm)
min. ⁄”
(11 mm)
min. 1⁄”
(30 mm)
16 ½”
(420 mm)
20 ½”
(520 mm)
1 ¼”
(31 mm)
min. 1 ⁄” (28 mm)
min. 4” (102 mm)
min. 4” (102 mm)
TDS1-20 ONLY
CORNER INSTALLATION
CORNER INSTALLATION WITH TWO PRODUCTS
Provide a support behind
the chassis to screw into
TDD1-20, TDT1-20 & TB1-20 ONLY
Provide a support above the
chassis to screw up into