User Guide 30" All Grill, LP Gas

Table Of Contents

LEAK TESTING

Prepare soap solution by combining

one part liquid detergent and one

part water. Pour into a spray bottle.

Ensure all control valves are in the

OFF position before turning the gas

supply ON.

Check all connections from the

supply line or LP cylinder by

applying the solution around the

connection, tubing and end of the

manifold. Soap bubbles will appear

where a leak is present.

A complete gas tightness check must be performed at the installation site. Periodically

check the whole system for leaks, or immediately if the smell of gas is present.

When using a LP gas cylinder ensure it is installed in a vertical position to provide the

required vapor withdrawal.

If a leak is present

Immediately turn the gas supply

OFF and tighten any leaking connections. Turn gas ON,

and recheck. If you cannot stop a gas leak turn the gas supply OFF and call your local gas

utility or the dealer you purchased the appliance from. Only parts recommended by the

manufacturer should be used on the unit, substitution can void the warranty.

Changing the LP cylinder

Ensure the main tank valve is turned off before turning the coupler counter clockwise, the

inlet will then disengage. Remove the inlet from the tank valve opening. Your local LP filling

station should be equipped with the proper equipment to fill your tank.

Do not attempt to remove, repair or replace the regulator/hose assembly. This must be

done by qualified and licensed technician only.

leak points

NG:

leak points

LP: