Use and Care Guide

USING THE SIDE BURNER

LIGHTING INSTRUCTIONS

First remove the burner cover and any cooking utensils from the burner grate. Push and turn the control knob

to the “HI” position until the burner is lit or 4 seconds pass. If the burner doesn’t ignite, wait 5 minutes for any

accumulated gas to dissipate then try again. If the burner will not light after several attempts, check the trouble-

shooting instructions on page 18.

MATCH LIGHTING

Hold a lit fireplace match near the burner ports, turn the control knob counterclockwise to “HI”. Rotate the knob

immediately once the burner is lit to the desired setting.

Note:

If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been

turned “off”. This “extinction pop” is normal for propane gas.

FIG. 11 BGC132 Shown

Control

Knob