user manual

dCS Verona User Manual Manual for Software Issue 1.0x
dCS Ltd September 2004
Manual filename: Verona Manual v1.0x.doc Page 19 email: [e-mail]
English version web-site: www.dcsltd.co.uk
The checking routine will find a sequencing error and Non Seq or Bad CD! will
appear on the display.
do this: Turn the power off and on to reboot. This message will scroll across the display:
Bad CheckSum – Press Function button to attempt recovery
or Bad CheckSum – Press Mute button to attempt recovery
or Bad CheckSum – Press Menu button to attempt recovery,
depending on the model.
do this: Press the appropriate button once.
The original software is retrieved from the internal backup while displaying
Wait... . This may take a few minutes. When recovery is complete, the unit
re-boots.
do this: Run the CD Update routine again to load the new software.
Factory
FactoryFactory
Factory – Restoring Factory Defaults
This feature sets most of the parameters back to the factory default settings.
This can be useful if the settings are accidentally changed and you need to
reset the unit to a standard configuration, or your children play with it.
do this: Open the Menu and step through until the display shows Factory.
do this: Press the
Select button and leave the menu to time out.
The unit will return to normal operation set up as follows:
• Clock Frequency to 44.1kHz
• Dither to Off
• Couple to TTL
• Display brightness to Bright 4
• Timeout to 15 secs