Install Guide

ManualsBrandsDCS ManualsBarbecue24 Inch Power Burner with 70000 BTU, Cast Brass Burner, Small Pot Insert, Removable Drip Tray, Stainless Steel Cover and Weather Resistant: Natural Gas

GAS CONNECTION

Connection: LP Hose with a Type 1 quick disconnect and regulator. Operating pressure: 11.0” W.C.

To operate your power burner on LP gas utilizing a 20lb type 1 cylinder, then a built-in LP

tank restraint must be installed prior to initial use of the power burner. The Installer must

supply ½” ID Flex hose and fixed pipe and a flare adaptor

BUILT-IN LP CONNECTION LEAK TESTING

When an LP unit is being directly connected to an LP house system, you must follow the

natural gas connection guidelines. The installer must provide the proper gas regulator to

reduce the gas pressure to 11” W.C.

1/2” ID flex hose with

1/2” NPT fittings*

Enclosure wall

Tank retention

device*

20lb LP tank*

1/2” NPT fixed pipe*

adapter 3/8” flare

fitting 1/2” NPT female

LP regulator/

hose assembly

*not supplied

base of product

open top manifold

Changing the LP cylinder

Ensure the main tank valve is turned off before turning the coupler counter clockwise, the

inlet will then disengage. Remove the inlet from the tank valve opening. Your local LP filling

station should be equipped with the proper equipment to fill your tank.

Do not attempt to remove, repair or replace the regulator/hose assembly. This must be

done by qualified and licensed technician only.

Prepare soap solution by combining

one part liquid detergent and one

part water. Pour into a spray bottle.

Ensure all control valves are in the

OFF position before turning the gas

supply ON.

Check all connections from the

supply line or LP cylinder by

applying the solution around the

connection, tubing and end of the

manifold. Soap bubbles will appear

where a leak is present.

A complete gas tightness check must be performed at the installation site. Periodically

check the whole system for leaks, or immediately if the smell of gas is present.

When using a LP gas cylinder ensure it is installed in a vertical position to provide the

required vapor withdrawal.

If a leak is present

Immediately turn the gas supply

OFF and tighten any leaking connections. Turn gas ON,

and recheck. If you cannot stop a gas leak turn the gas supply OFF and call your local gas

utility or the dealer you purchased the appliance from. Only parts recommended by the

manufacturer should be used on the unit, substitution can void the warranty.

leak points

NG:

LP: