Install Guide

13 13

BURNER ADJUSTMENT

FLAME HEIGHT ADJUSTMENT

LOW FLAME ADJUSTMENT

The valve for the outer burner feature an adjustable low setting. Due to fluctuations in gas

pressure, or heating value you may feel it necessary to increase or decrease gas flow in the

low position.

Remove the dial.

While holding the valve shaft with pliers,

insert a flat-tipped screwdriver into the

shaft and, while viewing the burner, adjust

to a minimum stable flame.

Push in and hold the selected dial

for 2 seconds before turning to HI.

Hold for 10 seconds to light the

selected burner.

Turn the control dial counter-

clockwise to the lowest setting.

BEZEL FRONT VIEW

Flames should be blue and stable with no yellow tips, excessive noise or lifting (Note: LP

units may have some yellow tipping). If any of these conditions exist, check the air shutter

and burner ports are clear. If cleaning these does not improve performance, the air shutter

for the outer burner can be adjusted as below.

yellow tips

noisy/lifting

blue + stable

With a screw driver, loosen the lock screw

on the face of the air shutter. If the flame

is yellow turn the air shutter counter-

clockwise, if the flame is noisy and tends

to lift turn the air shutter clockwise.

Light to check adjustment. If the flame

is blue and stable, tighten the air shutter

screw and replace all parts. If flame is still

unstable, repeat the above steps.

Ensure the power burner is

OFF and cool.

To access the air shutter, remove the

trivets and burner hob. The hob can

be removed by unscrewing the four

screws from each corner.

The burner should not be removed.

BURNER TOP VIEW