Installation guide

SELECT LOCATION:

The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out

of direct sunlight, away from heat sources and moisture. Units with fan cooled condensers can be built in. Unit

should be operated in a properly ventilated area with ambient temperatures above 40 degrees and below 100

degrees Fahrenheit.

Installation should be such that the cabinet can be moved for servicing if necessary.

CABINET CLEARANCE

■ Ventilation is required from the bottom front section of the unit. Keep this area open and clear of any obstructions.

■ The adjacent cabinets and counter top can be built around the unit as long as no top trim or counter top is

installed lower than the top of the upper drawer. See Fig. 04a.

SIDE TRIM INSTALLATION:

Prior to installation, align trim with the refrigerated drawer height and mark the screw hole locations. Attach side

trim to the inner side of the cabinet so that the trim faces outward (away from the appliance’s door) and fasten

with appropriate screws suitable for the type of cabinet material (Fig. 05).

INSTALLING DRAWERS

■ Place the unit in front of the counter opening. Make sure that the floor is protected when sliding the drawer unit

into place.

■ Det

ermine the minimum height of the counter top opening (Fig. 04a).

■ Lower the front and rear leveling legs (Fig. 04a) so the top of the drawer cabinet is 1/8” lower in the back of the

cabinet and 1/2” lower in the front of the cabinet than the counter top opening.

■ Make the electrical connection by plugging the unit into the power outlet and locating the power cord so it will

not be damaged when the refrigerated drawer is installed.

■ Slide the refrigerated drawer into cabinet location and adjust the front legs until the unit is level and there is the

same amount of load on each leg.

INSTALLATION

HOW TO INSTALL YOUR OUTDOOR REFRIGERATED DRAWER

Fig. 04

24” Outdoor Refrigerated Drawers

DIMENSIONS

ISLAND PREPARATION WITH NO SIDE TRIM

15-1/8

3-1/2”

24-1/8

ISLAND PREPARATION WITH SIDE TRIM INSTALLATION

Mounting

screw not

provided

Fig. 05

Fig. 04a