DOUBLE SIDE BURNER SBE1 Models INSTALLATION GUIDE US CA 592072A 11.
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electric shock or death. ! DANGER IF YOU SMELL GAS • Shut off gas to the appliance. • Extinguish any open flame. • Open lid. • If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department.
SAFETY AND WARNINGS ! WARNING! ! WARNING! Hot Surface Hazard Failure to follow this advice may result in fire, burns, scalds or personal injury. Explosion Hazard Failure to follow this advice may result in injury or death • Accessible parts may become hot during use. • If you smell gas, do not use the appliance. • When in use, do not touch the burner, grate, or immediate surrounding area as these areas become extremely hot. Clean the with caution.
SAFETY AND WARNINGS zz zz Do not store a full LP tank in direct sunlight. After a period of storage or non-use, the appliance should be checked for gas leaks, deterioration, proper assembly, and burner obstructions before use. Gas requirements zz zz General Use zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz This appliance is not intended to be installed in or on recreational vehicles, trailers or boats.
PRODUCT DIMENSIONS k J l g a f e b FRONT h D I PROFILE PRODUCT DIMENSIONS c INCHES MM A Overall height (excluding burners and pan supports) 10 5/8 268 B Overall width 14 11/16 373 26 7/8 683 22 9/16 573 11 7/8 301 9 15/16 253 9/16 15 H Depth of control panel to front of chassis 2 3/16 55 I Depth from control panel to rear of product 25 1/2 647 J Depth of lid 23 585 K Width of lid 14 3/8 365 L Height of lid 1 11/16 43 C Overall depth (excluding dials) D Depth of
CUTOUT DIMENSIONS STANDARD CUTOUT The side burner can be installed into a combustible enclosure with zero clearance from the back, side and bottom below the counter top level. A minimum of 6” (152mm) from the back and sides must be maintained from the side burner above the cooking surface.
ELECTRICAL CONNECTION All units are supplied with a 12V power transformer to operate the products ignition and dial illumination features. The transformer is sealed in a box with an attached power supply cord. Electrical requirements Use only a Ground Fault Interrupter (GFI) protected circuit with this product.
GAS CONNECTION GAS REQUIREMENTS Verify the type of gas supply to be used, either natural or LP, and make sure the marking on the appliance rating plate agrees with that of the supply. The rating plate is located on the underside of the drip tray. Never connect an unregulated gas line to the appliance. You must use a gas regulator even if the supply is controlled. Gas conversion kits are available from Customer Care.
GAS CONNECTION BUILT-IN LP CONNECTION When an LP unit is being directly connected to an LP house system, you must follow the natural gas connection guidelines. The installer must provide the proper gas regulator to reduce the gas pressure to 11” W.C. adapter 3/8” flare fitting 1/2” NPT female base of product open top manifold LP regulator/ hose assembly Connection: LP Hose with a Type 1 quick disconnect and regulator. Operating pressure: 11.0” W.C.
LEAK TESTING A complete gas tightness check must be performed at the installation site. Periodically check the whole system for leaks, or immediately if the smell of gas is present. When using a LP gas cylinder ensure it is installed in a vertical position to provide the required vapor withdrawal. Prepare soap solution by combining one part liquid detergent and one part water. Pour into a spray bottle. Ensure all control valves are in the OFF position before turning the gas supply ON.
INSTALLER CHECKLIST IMPORTANT! Read all installation instructions in this manual to see if the unit has been correctly installed. Ensure that installation has been completed correctly before use.
DCSAPPLIANCES.COM © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available. US CA 592072A 11.