Owner's Manual

80
gb
Problem Possible causes Solution
The coee cream is dark (the coee ows
slowly from the spout)
The ground coee is too tightly pressed Decrease the amount of ground coee
Too much ground coee Reduce the quantity of ground coee
The espresso boiler outlet is blocked Clean as indicated in “Cleaning the lter”
The lter is blocked Only use coee ground specically for
espresso coee machines and it must not
be damp
The coee is too nely ground Change the quality of the ground coee
powder
The ground coee is too ne or is damp Only use coee ground specically for
espresso coee machines and it must not
be damp
Incorrect type of ground coee Change the quality of the ground coee
powder
The milk does not froth when making a
cappuccino
Milk not cold enough Always use milk at refrigerator
temperature
Cappucccino maker is dirty Carefully clean the holes in the
cappuccino nozzle
Troubleshooting
Before using this appliance ensure that the voltage indicated on the
product corresponds with the main voltage in your home, if you are
in any doubt about your supply contact your local electricity company.
The exible mains lead is supplied connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity. Should this plug not t the socket
outlets in your home, it should be cut o and replaced with a suitable
plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should
therefore be properly disposed of and not left where children might
nd it and plug it into a supply socket - with the obvious consequent
danger.
Please note: We recommend the use of good quality plugs and wall
sockets that can be switched o when the machine is not in use.
IMPORTANT: The wires in the mains lead tted to this appliance are
coloured in accordance with the following code:
GREEN ANDYELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
- The wire which is coloured green and yellow must be connected to
the terminal in the plug which is marked with the letter E or by the
earth symbol or coloured green or green and yellow.
- The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
- The wire which is coloured brown must be connected to the termi-
nal which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely retai-
ned in each terminal. Do not forget to tighten the mains lead clamp on
the plug. If your electricity supply point has only two pin socket outlets,
or if you are in doubt, consult a qualied electrician. Should the mains
lead ever require replacement, it is essential that this operation be car-
ried out by a qualied electrician and should only be replaced with a
exible cord of the same size. After replacement of a fuse in the plug, the
fuse cover must be retted. If the fuse cover is lost, the plug must not be
used until a replacement cover is obtained. The colour of the correct re-
placement fuse cover is that of the coloured insert in the base of the fuse
recess or elsewhere on the plug. Always state this colour when ordering
a replacement fuse cover. Only 13amp replacement fuses which are asta
approved to B.S. 1362 should be tted.
This appliance conforms to the Norms EN 55014 regarding the suppres-
sion of radio interference.
Warning - this appliance must be earthed
Green and Yellow to Earth
13 amp Fuse
Brown to live
Cord Clamp
Blue to
neutral
Electrical connection (UK ONLY)